This standard sets minimum requirements for shop- and field-applied polyurethane interior linings and exterior coatings used in the potable water supply indus. Find the most up-to-date version of AWWA C at Engineering AWWA B Liquid Oxygen for Ozone Generation for Water, Wastewater, and . AWWA C Polyurethane Coatings for the Interior and Exterior of Steel.
|Published (Last):||10 September 2009|
|PDF File Size:||7.1 Mb|
|ePub File Size:||17.89 Mb|
|Price:||Free* [*Free Regsitration Required]|
Consult the manufacturer for conditions and limitations.
AWWA C – Polyurethane Coatings and Linings for Steel Water Pipe and Fittings | Engineering
Conditions not described in this standard. This standard sets minimum requirements for shop- and field-applied polyurethane coatings and linings used in the water supply industry. Top Categories Terms of Awwa c222. This Standard References Showing 10 of Click here to awwa c222 or ad will close in 15 seconds.
AWWA C – POLYURETHANE COATINGS AND LININGS FOR STEEL WATER PIPE AND FITTINGS | Engineering
IHS Standards Expert subscription, simplifies and expedites the process for finding and managing standards by giving you awwa c222 to standards from over standards developing organizations SDOs. Coating and lining systems.
This standard is awda for individual purchase. The purpose of this standard is to provide the minimum requirements for polyurethane coating and lining systems for steel awwa c222 pipe and fittings including materials, surface preparation, testing, handling, and packaging requirements.
They are fast setting cure to handle in awwa c222 than 30 minutes and are applied in one coat direct to steel.
Polyurethanes are used for steel water pipe, awwa c222 sections, welded joints, awwa c222, and fittings for steel water pipelines installed underground or underwater operating under normal conditions. Mitigate liability and better understand compliance regulations Boost efficiency: The coating and lining systems shall consist of an ASTM D16 Type V thermoset, aromatic polyurethane plastic polymer that is the reaction product of diphenylmethane diisocyanate resin and polyol resin, polyamine resin, or a mixture of polyol and polyamine resins.
Purpose The purpose of this standard is to provide the minimum requirements for polyurethane awwa c222 and lining systems for steel water pipe and fittings including materials, surface preparation, testing, handling, and awwa c222 requirements.
However, there is a wide variety of polyurethane technologies available on the market that may contain up to 10 percent solvent or are slower setting that also meet the requirements of this standard.
Polyurethanes have performed at higher temperatures. The systems described in this standard are not intended for use awwa c222 pipe that will be bent after awwa c222 coating system or lining system has been applied. Typically, these systems are solvent free or almost solvent free less than 10 percent solvent by volume.
Speed up research, capture and reuse expertise For additional product information, visit the IHS Standards Expert page. Identify unmet needs and discover next-generation awea Improve quality by leveraging consistent standards to meet customer and market requirements Minimize risk: Price and Buy this Standard View Pricing.
AWWA steel pipe coating awwa c222 lining standards are written for and based on the service temperature of potable water.